Bosch GWS18V-13C Instrucciones De Funcionamiento Y Seguridad página 18

Sanding Accessories Assembly
BACKING PAD
Before attaching a backing
pad be sure its maximum
safe operating speed is not exceeded by the
nameplate speed of the tool.
Wheel guard may not be
used for most sanding oper-
ations. Always reinstall wheel guard when con-
verting back to grinding operations.
Do not use the Quick-Clamp-
ing Nut with backing pad for
sanding accessories.
TO INSTALL BACKING PAD AND SANDING
DISC (Not Included)
Disconnect battery pack from tool.
Attach Hand Shield (Fig. 1 & 2, 6). Set the tool
on its top side (spindle up). Place the rubber
backing pad onto the spindle shaft. Center the
sanding disc on top of the backing pad. Insert
the lock nut through the disc and thread onto
the spindle as far as you can with your fingers.
Press in the spindle lock, then tighten the back-
ing pad securely with lock nut wrench (Fig. 7).
TO REMOVE: Reverse procedure.
WIRE CUP BRUSH ASSEMBLY
Disconnect tool from the power supply. Attach
Hand Shield (Fig. 1 & 2, 6). Wire cup brushes are
equipped with their own threaded hub, simply
thread on to spindle. Be sure to seat against
shoulder before turning tool "ON".
TO REMOVE: Reverse procedure.
WIRE WHEEL ASSEMBLY
Disconnect tool from the power supply. Install
Type 27 Wheel Guard (Fig. 8, 8). Wire wheels
are equipped with their own threaded hub, sim-
ply thread on to spindle. Be sure to seat against
shoulder before turning tool "ON".
TO REMOVE: Reverse procedure.
160992A7PL GWS18V-13CP 202206.indd 18
Assembly
Fig. 7
Spindle
Fig. 8
Spindle
-18-
(6)
Backing
Pad
(sold
separately)
Sanding
Disc
Lock Nut
(sold separately)
Wire Cup Brush
(8)
Wire Wheel
6/22/22 2:39 PM