Descargar Imprimir esta página

Bosch GWS18V-13C Instrucciones De Funcionamiento Y Seguridad página 21

Ocultar thumbs Ver también para GWS18V-13C:

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLING DRY DIAMOND WHEEL (Fig. 12)
1. Place the backing flange on the spindle.
Turn flange until it locks with the base of the
spindle.
2. Place the dry diamond wheel onto the spin-
dle and align the arbor hole of the grind-
ing wheel with the shoulder of the backing
flange.
3. Tighten lock nut with supplied lock nut
wrench while holding spindle lock.
TO REMOVE: Reverse procedure.
Inserting and Releasing
Battery Pack
This tool is equipped with Automatic Restart
Protection. This feature helps prevent acciden-
tal startups after power has been interrupted,
e.g. the battery was removed with the switch
locked in the on position. To resume operation,
turn the side switch to the off position, and back
to on position to restart the tool.
Make sure that the Side Switch (Fig. 14, 2a) is
in the off position before inserting or removing
battery pack. To insert the battery pack slide it
into the housing until the battery pack locks into
position.
Your tool is equipped with a secondary locking
latch to prevent the battery pack from complete-
ly falling out of the handle, should it become
loose due to vibration.
To remove the battery pack, press the battery
pack release button and slide the battery pack
forward.
Press the battery pack release button again and
slide the battery pack completely out of tool
housing (Fig. 13).
160992A7PL GWS18V-13CP 202206.indd 21
Assembly
Fig. 12
Lock Nut
Dry Diamond
Wheel
Lock Nut
Backing
Flange
Spindle
Fig. 13
-21-
Backing
Flange
Spindle
Dry
Diamond
Wheel
6/22/22 2:39 PM

Publicidad

loading

Este manual también es adecuado para:

Gws18v-13pGws18v-13pn