Bosch GWS18V-13C Instrucciones De Funcionamiento Y Seguridad página 20

Masonry Cutting Guard Assembly
A type 27 grinding wheel
guard may not be used for
all tool operations. Do not discard guard when
not in use. Always reinstall wheel guard when
converting back to grinding operations.
To improve ergonomics of your grinder when
cutting masonry, gearbox must be rotated rela-
tive to the position of the switch as the tool was
assembled at the factory.
ROTATE GEARBOX (Fig. 10)
1. Unplug tool from power source.
2. Completely unscrew the four screws be-
tween the gear housing and motor body.
3. Rotate gear housing to the proper orientation
without removing motor from the housing.
a. For the Slide Switch models (Fig. 11, 2a),
rotate gear housing 180 degrees, so the
Side Switch (2a) is 90 degrees from the
X-Lock Accessory Mount.
b. For the Paddle Switch models (Fig. 11,
2b), rotate gear housing 90 degrees, so
the Paddle Switch (2b) is facing the work
piece.
4. Screw in and tighten the four screws you re-
moved.
5. The screw holding the Guard Release Lever
(11) is longer than the other screws, this
long screw must stay with the Guard Release
Lever when re-attaching gear housing for the
quick release button to operate properly.
6. Attach proper dust collection guard with
foot and accessory.
INSTALLING MASONRY TYPE 1
CUTTING GUARD
1. Use tool adjusted as show in figures 10 and 11.
2. Unplug tool from power source.
3. Unscrew and remove side handle.
4. Slide dust extraction guard on spindle neck.
5. Rotate attachment until stability bracket and
hole for side handled are aligned.
6. Screw in side handle to secure stability brack-
et between the tool housing and handle.
7. Adjust guard to desired depth of cut.
TO REMOVE: Reverse procedure.
160992A7PL GWS18V-13CP 202206.indd 20
Assembly
Fig. 10
Fig. 11
180
Degress
-20-
Spring
(11)
(x3)
(2a)
4x
180
Degress
(2b)
(under
tool)
6/22/22 2:39 PM