Bosch GWS18V-13C Instrucciones De Funcionamiento Y Seguridad página 17

Abrasive TYPE 41/1A and 27A/42
Wheel Assembly
Always use Type 41/1A pro-
tection guard for cutting.
Using the optional Type 41/1A wheel guard, it
is possible to perform limited cutting on small
stock such as metal tubes, piping or rebar.
Do not attempt to cut large stock or sheets of
metal as this tool is not designed to be a dedi-
cated cutting tool.
1. Disconnect battery pack from tool.
2. Be sure that Type 41/1A Wheel Guard (Fig. 6,
12) is in place for cutting.
3. When using mounting wheels, thread back-
ing flange onto spindle, then place wheel on
the spindle.
4. Thread on the Quick-Clamping Nut (Fig. 6, 9)
and tighten nut using the fold-up bar, while
holding the spindle lock.
TO REMOVE: Reverse procedure.
Type 1 Abrasive Straight
Grinding Wheels
Do not use Type 1 abrasive
wheels
straight/die grinding. This tool is not designed
for use with Type 1 abrasive straight/die grind-
ing wheels.
160992A7PL GWS18V-13CP 202206.indd 17
Assembly
Type 41/1A
Cutting Wheel
designed for
Type 27A/42
Cutoff Wheel
-17-
Fig. 6
Spindle
(12)
Backing
Flange
(9)
Type 27A/42
Cutoff Wheel
Spindle
Backing
Flange
Lock Nut
(sold separately)
6/22/22 2:39 PM