Bosch GWS18V-13C Instrucciones De Funcionamiento Y Seguridad página 4

d. Under abusive conditions, liquid may be
ejected from the battery, avoid contact. If
contact accidentally occurs, flush with wa-
ter. If liquid contacts eyes, additionally seek
medical help. Liquid ejected from the bat-
tery may cause irritation or burns.
e. Do not use a battery pack or tool that is
damaged or modified. Damaged or modified
batteries may exhibit unpredictable behavior
resulting in fire, explosion or risk of injury.
f. Do not expose a battery pack or tool to fire
or excessive temperature. Exposure to fire
or temperature above 265 °F may cause ex-
plosion.
g. Follow all charging instructions and do not
charge the battery pack or tool outside the
Safety Warnings Common for Grind-
ing, Sanding, Wire Brushing, and
Abrasive Cutting-Off Operations:
a. This power tool is intended to function as a
grinder, sander, wire brush or cut-off tool.
Read all safety warnings, instructions, il-
lustrations and specifications provided
with this power tool. Failure to follow all in-
structions listed below may result in electric
shock, fire and/or serious injury.
b. Operations such as polishing are not rec-
ommended to be performed with this pow-
er tool. Operations for which the power tool
was not designed may create a hazard and
cause personal injury.
c. Do not use accessories which are not spe-
cifically designed and recommended by the
tool manufacturer. Just because the acces-
sory can be attached to your power tool, it
does not assure safe operation.
d. The rated speed of the accessory must
be at least equal to the maximum speed
marked on the power tool. Accessories run-
ning faster than their rated speed can break
and fly apart.
e. The outside diameter and the thickness of
your accessory must be within the capacity
rating of your power tool. Incorrectly sized
160992A7PL GWS18V-13CP 202206.indd 4
General Power Tool Safety Warnings
Safety Rules for Grinders
temperature range specified in the instruc-
tions. Charging improperly or at tempera-
tures outside the specified range may dam-
age the battery and increase the risk of fire.
6. Service
a. Have your power tool serviced by a quali-
fied repair person using only identical re-
placement parts. This will ensure that the
safety of the power tool is maintained.
b. Never service damaged battery packs. Ser-
vice of battery packs should only be per-
formed by the manufacturer or authorized
service providers.
accessories cannot be adequately guarded
or controlled.
f. Threaded mounting of accessories must
match the grinder spindle thread. for ac-
cessories mounted by flanges, the arbour
hole of the accessory must fit the locating
diameter of the flange. Accessories that do
not match the mounting hardware of the
power tool will run out of balance, vibrate
excessively and may cause loss of control.
g. Do not use a damaged accessory. Before
each use inspect the accessory such as
abrasive wheels for chips and cracks, back-
ing pad for cracks, tear or excess wear, wire
brush for loose or cracked wires. If power
tool or accessory is dropped, inspect for
damage or install an undamaged acces-
sory. After inspecting and installing an ac-
cessory, position yourself and bystanders
away from the plane of the rotating acces-
sory and run the power tool at maximum
no-load speed for one minute. Damaged
accessories will normally break apart during
this test time.
h. Wear personal protective equipment. De-
pending on application, use face shield,
safety goggles or safety glasses. As ap-
propriate, wear dust mask, hearing protec-
tors, gloves and workshop apron capable of
stopping small abrasive or workpiece frag-
-4-
6/22/22 2:39 PM