AENO EK1S Manual Del Usuario página 6

ENG Electric smart kettle AENO EK1S is designed for heating and boiling
drinking water.
Specifications
Supply voltage: 220–240 V (AC); frequency: 50/60 Hz. Power: 1850.0–2200.0 W.
Dimensions (L×W×H): 223×158×241 mm. Capacity: 1.7 L. Control: through the
control panel (heating modes: 40, 70, 80, 90, 100 °C); through the application
AENO (temperature control range: 25–100 °C). Wi-Fi module data: IEEE 802.11
b/g/n, 2.4 GHz frequency. Maintaining the set temperature: 1 hour. Emission
power: +20 dBm/100 mW.
Scope of Supply (see figure)
Smart kettle AENO EK1S, stand (3), quick start guide, warranty card.
Limitations and Warnings
Please read this document carefully before using the device. The kettle is
intended for domestic use only and may not be used outdoors. Before using it
for the first time make sure that the mains parameters correspond to the
specifications of the device. Do not use a damaged device. The device should
be repaired by a qualified technician. Do not allow the power cord to come in
contact with sharp edges or hot surfaces. Do not immerse the power cord or
plug, the kettle, or the stand in water or other liquids. Install the device on a flat,
stable surface, away from external heat sources or other electrical appliances.
Do not turn on an empty kettle. Do not allow children to use the device without
adult supervision and/or play with it. Do not open the kettle while the water is
boiling or during the first few minutes after boiling. Be careful when pouring
hot water, do not tilt the kettle with water too sharply. Before you lift the kettle
make sure that the lid is tightly closed. Do not touch the hot housing, lift the
device from the stand (3) only by the handle (4). Do not pour water below the
"MIN" mark and above the "MAX" mark on the inside of the housing. Use the
device only with the supplied stand. Use only manufacturer-recommended
accessories, consumables and/or replacement parts. The kettle is for heating
and boiling water only. Use purified water to reduce scale formation. Unplug
the device when not in use and before cleaning it. Detailed information can be
6 aeno.com/documents