AENO EK1S Manual Del Usuario página 7

found in the Installation and Operation manual available for download at
aeno.com/documents.
Preparing the device for operation
Before first use fill the kettle to the "MAX" mark, boil and drain. Repeat the
procedure. Let the kettle cool down. Wipe the exterior and interior of the device
with a dry cloth. Make sure there is no moisture left on the stand and the kettle.
Operating the device
Perform the following steps before boiling, heating, and heating with
temperature maintenance:
1. Remove the kettle from the stand (3). Press the button (1) to open the
lid (6). Draw just the right amount of water.
2. Close the lid tightly and place the kettle on the stand.
3. Plug the power cord plug (9) into a power outlet.
4. Two short beeps will sound. Make sure that the kettle outline light (2) turns
on and off and the four blue lights on the control panel (5) are lit.
Boiling
1. Press the "Start/Stop" button (7) to start the boiling process. The indicators
will go out and the backlight will light up and flash red.
2. After water boiling the kettle will give two short beeps and the boiling
process is finished.
3. The backlight will turn off within one minute.
Heating with temperature maintenance
1. Use the "+/-" button (8) to select the desired temperature (40, 70, 80 or
90 °C).
2. Press the "Start/Stop" button (7). The backlight (2) as well as the blue
indicator next to the selected heating mode will start flashing.
3. When the kettle reaches the set temperature it will give one short beep and
will maintain the set temperature for 1 hour.
aeno.com/documents 7