Kärcher WD 5 P Instrucciones De Operación página 10

Note
Regularly replace the filter bag when
full as a filter bag that is too full could
be damaged. The filling level of the fil-
ter bag depends on the dirt being vac-
uumed. The filter bag should be
replaced more often in the case of fine
dust, sand, etc.
Wet vacuuming
ATTENTION
Wet vacuuming with a filter bag
Device damage
Do not use a filter bag when vacuum-
ing wet debris.
ATTENTION
Operation with full container
When the container is full, the float
switch closes the suction opening and
the device runs at a higher speed.
Switch off the device immediately and
empty the container.
Note
If the device falls over, the float can al-
so close. To make sure the device
works absorbent again, set up the de-
vice, switch it off, wait 5 seconds and
then switch it on again.
Working with power tools (only
for devices with a built-in socket)
CAUTION
Unintentional starting of the power
tool
Injuries or material damage
Make sure that the power tool is ready
for operation as soon as it is connected
to the device socket.
Note
Depending on the model selected, an
adapter or an adapter and a thin tool
hose are included in the scope of deliv-
ery.
10
1. Connect the suction hose.
2. If necessary, the adapter can be ad-
justed to the connection diameter of
the power tool with a suitable tool.
3. Option A) Fit the adapter on the han-
dle of the suction hose. Connect the
suction hose to the power tool using
the adapter.
Option B) With some power tools,
the handle of the suction hose can
be connected directly to the power
tool.
A
English
C
B