Kärcher WD 5 P Instrucciones De Operación página 11

4. Plug the power plug of the power
tool into the device socket.
C
2.
5. Set the power switch to MAX
The power can be regulated using
the rotary switch.
The suction is activated automati-
cally.
Note
Note the maximum connected load
(see information on the device socket).
Note
The suction turbine starts up with a 0.5
second delay when the power tool is
switched on. When the power tool is
switched off, the suction turbine contin-
ues to run for approx. 5 seconds in or-
der to suck in the residual dirt in the
suction hose.
1.
Integrated filter cleaning system
Note
The filter cleaning system is designed
for vacuuming large quantities of fine
dust without a filter bag inserted. The
filter cleaning system allows the soiled
flat pleated filter to be cleaned at the
push of a button and the suction perfor-
mance to be increased again.
 Place the handle of the suction hose
in the designated parking position
on the device head. Press the filter
cleaning button three times with the
device switched on, waiting 4 sec-
onds between the individual actua-
.
tions.
1.
Filter cleaning
Note
After pressing the filter cleaning button
several times, check the container for
its filling volume. Otherwise dirt can es-
cape when the container is opened
Blower function
The blower function can be used to
clean areas that are difficult to reach or
where vacuuming is not possible, e.g.
leaves in a gravel bed.
 Insert the suction hose into the blow-
er connection. The blower function
is now activated.
English
2.
3 x PUSH
11