Ryobi PTS01 Manual Del Operador página 6

PRODUCT SPECIFICATIONS
Motor ...................................................................... 18 V DC
Blade Diameter ....................................................... 6-1/2 in.
Blade Arbor ............................................................... 5/8 in.
Track Size ........................................................27.5 in. each
Bevel Capacity ...................................................... -1˚ to 48˚
No Load Speed .........................................4,300/min (RPM)
UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled to the
product by the manufacturer and require customer instal-
lation. Use of a product that may have been improperly
assembled could result in serious personal injury.
 This saw has been shipped with a tie-wrap securing it in
the plunge position. To release the saw, push down on
the top of the front handle, cut the tie-wrap, and slowly
allow the saw to raise to its fully raised position.
WARNING:
The saw's body is spring loaded. Hold the front handle
down to prevent it from snapping up when cutting the
tie-wrap. Failure to do so could result in possible seri-
ous injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
FEATURES
Cutting Depth at 0º
with track ...................................................... 1-15/16 in.
without track ..................................................... 2-1/8 in.
Cutting Depth at 45º
with track ........................................................ 1-7/16 in.
without track ................................................... 1-9/16 in.
ASSEMBLY
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
product when assembling parts.
INSTALLING THE BLADE
See Figures 1 - 4, page 18.
WARNING:
A 6-1/2 in. blade is the maximum blade capacity of the
saw. Never use a blade that is too thick to allow outer
blade washer to engage with the flats on the spindle.
Larger blades will come in contact with the blade guard,
while thicker blades will prevent blade screw from secur-
ing blade on spindle. Either of these situations could
result in a serious accident.
 Remove the battery pack from the saw.
 Remove the blade wrench from the storage area.
NOTE: Two wrenches are included with the saw, a small
one for the track and a large one for the blade.
 Place the plunge depth control lever in the blade change
position.
 Depress the lock-off button.
 Grasp the front handle and apply downward pressure to
lower and expose the blade screw. Continue pressing
down to lower the saw to its fully lowered position.
6 - English