SBS TEEARSETBT410K Manual De Instrucciones página 3

UK
Warning
Fully charge the headset before to use it, by using an
microUSB - USB.
Power on: press about 3 seconds the multifunction button,
the blue LED will flash 3 times and a beep sounds.
Power off: in standby mode, press and hold the
multifunction button until the red LED flashes once and a
beep sounds.
Associate: with device off, turn on the headset: when the
red and blue LED flash alternately the headset is ready
for pairing. Turn on Bluetooth on your device, and set
"search": when the headset's name appears in the list of
found Bluetooth, select it: the devices will connect and the
headset beeps.
Answer a call: telephone connected, press the
multifunction button once, the headset beeps.
End a call: During the call, press the multifunction button.
Call last number: Press the multifunction button twice.
Voice call: in stand-by, quickly press the multifunction
button (if supported).
Music Mode: in Music mode quickly press the function key
to pause and / or start.
Led meaning
Power: the blue LED flashes quickly 3 times
State Association running: red and blue LED flash
alternately
Charging: red LED
Full charge: blue LED
3