Publicidad
Idiomas disponibles
Idiomas disponibles
STOP
a. Press the "ON/OFF" key (2) to stop the air conditioner.
If the AUTO mode is not wanted, the desired conditions can be selected manually.
3.5 - ADJUSTING AIR FLOW DIRECTION
Adjust the direction of the air correctly in order to prevent the flow of air from being annoying (figure 3) or
generating irregular temperatures in the room.
a. Adjust the horizontal openings manually (fig.29).
b. Press the key (3) to activate operation of the vertical openings (fig.30).
3.5.1 - Air vertical flow adjustment
The air conditioner automatically adjusts the vertical flow of air, depending on the operating mode.
Activate this function while the unit is active.
• The SWING/DIRECT buttons will be disabled when the air conditioner is not operating
(also when the TIMER ON is set).
• Do not activate the air conditioner for long periods with the air downwards in cooling
or dehumidification modes.
Otherwise, humidity may form on the surface of the horizontal louvres, which could
fall onto the floor or furnishings.
• Do not move the vertical openings manually.
Always use the SWING button. If directed manually, malfunctioning may occur. If louvre
malfunctioning occurs, stop the conditioner and re-start it.
• When the conditioner is switched on immediately after it has been switched off, the
horizontal louvres may not move for approx. 10 seconds.
• The angle of opening of the horizontal louvres must not be too small, since performance
in COOLING or HEATING mode may not be perfect for the flow of air that is too narrow.
• Do not activate the equipment with the openings in closed position.
• When the air condition is connected to the power supply (initial supply), the openings
may cause a noise for 10 seconds. This is normal operation.
3.6- DEHUMIDIFICATION
START
Check that the unit is connected and is powered electrically.
a. Press the "MODE" key (1) to select "DRY" mode.
b. Set the desired temperature by pressing the "TEMP" keys (4).
c. When the remote control is "OFF", press the "ON/OFF" key (2) to start the air conditioner.
STOP
a. Press the "ON/OFF" key (2) to stop the air conditioner.
Fan speed cannot be adjusted when the unit is in AUTO and DRY modes.
3.7 - TIMER OPERATION
START
Check that the unit is connected and is powered electrically.
a. Press one of the TIMER keys (7 and 8) as desired.
The current adjustment of the timer is shown on the display at the side of the Timer ON and Timer OFF
indicators and will flash.
b. Press the "TEMP" keys (4) to select the desired time.
Forward
Backward
Every time one of the "TEMP" keys (4) is pressed, the time moves forward or backward by 30 minutes,
depending on the direction of pressing.
NEXYA S4 E INVERTER 9/12/18
EN - 15
Publicidad
