ManoMano Z2 Manual De Instrucciones página 12

5 During operations you need to use ear protectors, sturdy footwear and long trousers should be worn. Be very careful, when working, the
UK
blade is potentially hazardous for hands and feet. Always walk and never run while operating the machine.
6 During the machine transport and all the maintenance, cleaning, equipment change operations, the engine must be switched off.
7 Before leaving the machine, please switch the engine off.
8 Do not switch the machine on in closed rooms/areas where you can have carbon monoxide exhalations.
9 WARNING !! The petrol/gasoline is highly inflammable. Store fuel only in containers specifically designed fort he storage of such materials.
Don't fill the tank neither in closed areas, nor when engine is on, don't smoke and be careful to the petrol/gasoline loss from the tank. In case of
leak, don't try to switch the engine on but move the machine away from the area in order to avoid ignition source until the gasoline vapours fade
away. Re-place the tank caps and the gasoline box. Never open the cap of the fuel tank, or add fuel, while the engine is running or the unit is hot.
10 Keep attention to the exhaust pipe. The parts near the pipe can reach 80°C.
Replace the defective and/or worn out silencers Burn hazards !!!.
11 Do not work on excessively steep slopes and take every precaution when changing direction or pulling the machine towards you.
12 Before putting the machine into operations, check it visually and make sure all the accident prevention measures are working. It is absolutely
forbidden to exclude and/or to tamper with them. Replace worn or damaged elements.
13 In case the machine is incorrectly used, and/or the repairs are performed by non-authorized technical staff, and/or fitted by spare parts
other then original ones: any use other than that described above is prohibited and will involve the cancellation of the warranty and the refuse
all responsability from the manufacturer.
SAFETY DEVICE (Fig. 6)
n
when the relevant levers are released (1) and (2).
NOTES FOR WORKING WITH THE MOTOR-HOE (Fig. 6)
n
motor hoe firmly, push the spur into the ground. Pull the clutch lever (2) on the handlebar to begin hoeing. APPLICATIONS: working light or medium-
heavy ground, hoeing, breaking up, weeding, digging in composts or fertilisers, etc.
HOW TO ASSEMBLE YOUR MOTOR-HOE
n
packing case. For assembly to be completed, the step/by/step procedure is as follows.
FITTING THE DREWBAR (Fig. 2-3)
n
by turning the handle (2). The purpose of the transfer wheel (Fig. 3 part 1) is for transporting the motor hoe only. This can be fitted after turning the
drewbar by 180° and locking it in place with the wing screw (2). During motor hoe operation, the wheel should be removed: loosen the wing screw,
take off the drewbar and reposition it turned round as in Fig. 2
FITTING THE HANDLEBAR SUPPORT (Fig. 4)
n
plate, washers (3) and nuts (4). Fit the cable guide (5) as shown in the illustration.
7
All the motor-hoes feature accident-prevention devices. Such devices cause automatic disconnection of the drive
Unless otherwise agreed, the motor cultivator is delivered disassembled and placed in a
Fit the long side of the drewbar (Fig. 2 part 1) into the end part of the frame arm and lock in place
Fit the support (1) on the motor hoe using 4 screws (2) already positioned on the
With the motor running, rest the blades on the ground and, holding the