Pur Line RAFY 96 Manual De Instrucciones página 12

CONTROL PANEL:
You can select the functions as follows:
- ON/OFF: Press once this button to turn on the device. Press again this button to turn OFF.
- SPEED: Press this button to select desired fan speed, LOW-MID-HIGH, in circle turns. The corresponding air
flow speed indicator light will be displayed.
- MODE: Press this button to select desired wind mode, NORMAL-NATURE-SLEEP. The mode "Sleep" or "Nature"
indicator light will be displayed.
- COOL: Press once this button to start the evaporative cooling function. The corresponding indicator light will
be displayed.
Attention: The "Cold Wind" function must be powered off when there is no water or water shortage in the water
tank. This way is to avoid damaging the water pump and assure its using span.
- SWING: Press once this button to make swing of louvers, the SWING indicator will be displayed. Press again
to cancel this function.
- TIMER: It can be set between 1 to 12 hours, increase by 1 hour intervals. The numeric
display shows the time.
- IONIZER: Press once this button to release negative ions into the air, to freshen the air and
care health. Press again this button to cancel.
- HEAT: Press the heating switch on the side of the appliance. Press the HEAT button on the
control panel to switch from low heat (1000W) to high heat (2000W). The HEAT mode does
not work at the same time with other functions.
REMOTE CONTROL:
Remote control with the same functions as the unit control panel.
The remote control must be directed to the receiver of the unit when used,
the effective distance is about 4-5 meters.
ATTENTION:
a. Do not mix old and new batteries.
b. Remove the batteries when the remote control is not used for a long time.
CLEANING AND MAINTENANCE
· Unplug the appliance before cleaning.
· Empty water tank to avoid odor occurring when not in use.
· After few days operation, dust and dirt may reserve in water tank. It is recommended to change
water and clean water tank frequently.
· After long time operation, the filtration mesh becomes clogged with dust and dirt, which will
greatly affect the unit's performance. It is recommended to clean the filtration mesh frequently.
· Use a soft cloth to clean the appliance. Do not use solvents or harsh chemicals. Never use direct
water. Do not allow water to come in contact with the control panel.
· Do not clean with metal sourcing pads. It may scratch the surface or cause electrical shock.
FILTER
Remove the filters in order.
Use a soft brush, and if necessary some water and mild detergent.
When everything is dry, place each filter in corresponding position.
WATER TANK
Take out the water tank. Wipe the scale in the water tank by using towel wet by a little detergent. Then pour a
little amount of water into the water tank and spill the dirt water.
EN
10