Cooper Lighting Solutions Greengate RC3DEHC Instrucciones De Instalación página 10

Room Controller for Healthcare
Connecting the Daylight Sensor to the Room Controller
One DSRC-FMOIR daylight sensor may be connected to the Room Controller. The daylight sensor connects using only the
provided GGRC-COUPLER and QuickConnect Cable to ports 3 or 4 of the Room Controller.
Once the daylight sensor mounting area is prepared, attach the GGRC-COUPLER to the sensor. Connect the Daylight Sensor
to one of the two sensor ports on the Room Controller. Using the shortest length of QuickConnect cable from your QuicKit
that will reach the desired location.
Connect the daylight sensor to the coupler.
Connect a QuickConnect cable between the
coupler and one of the sensor Click & Go
ports on the Room Controller.
White
Switchpack
Receptacle
Red
BMS/Out
Black Sensors
Green Sensors
Slider
Station
Wallstations
-
A/V
+
Mode
-
Demand
+
Response
-
Alert
+
Mode
-
Time
+
Clock
Energy Options DIP Switch
Demand Response Occupancy
1 2
Default 10% Occ
20% Vac (default)
30%
40%
0-10V Dimming Outputs
- -
+ +
Dimmer 3 Dimmer 2
If occupancy sensors are being used in your
room control strategy, an alternate wiring
method may be used. Wire the daylight sensor
to either the Room Controller or to the nearest
free input/output device.
www.cooperlighting.com
6
5
4
3
2
1
Not Used
3 4
-
+
Dimmer 1
Dimmer 3 - Dimmer 2 - Dimmer 1 -
+ + +
0-10V Dimming
GGRC-COUPLER
(Daylight Sensor Coupler)
QuickConnect Cable
(Class 2)
Greengate
GGRC-COUPLER
Click & Go Port
(one on each side)
9850-000366-04 page 10
October 2021