Vermeiren LiNX 200 Manual De Instrucciones página 7

displays a fault on its fault indicator and the controller does not perform normally.
o

Turn the controller off:
when you do not use it;
o
before you get in or out of the wheelchair;
o
if your vehicle drives by itself or against your will. When you turn the controller off, the
o
vehicle will halt.
In case a serious incident has occurred involving your product, notify Vermeiren or your
specialist dealer as well as the competent authority in your country.
3 Driving
1. Press the ON/OFF button.
2. If the light on the ON/OFF button is green, the wheelchair is powered and ready to go.
3. Check the battery status indicator. Charge the battery if necessary (see §4.3).
4. Select the driving program and adjust the driving speed using the speed switch, see drive
functions in §4.7.
5. Start moving the wheelchair by operating the joystick slowly forwards/backwards.
6. The speed will increase when you push the joystick further out of the centre.
7. To turn left or right, push the joystick to the left or right. Use your direction indicators when
driving outdoors, see §4.9.
8. To brake, move the joystick to neutral position.
9. After arrival, check the battery status and press the ON/OFF button.
10. Charge the battery if necessary.
5
EN
LiNX 200
2023-03
Driving
NL