Publicidad
Idiomas disponibles
Idiomas disponibles
2
Getting started
Installation tips
First switch off all devices (TV and HDMI sources) before connecting them to the
MegaView 251 Pro. If a device cannot be turned off, please remove its plug from
the wall socket.
For the best picture and sound quality, only use High Speed HDMI
cables.
Connecting the transmitter and receiver
In order to check proper functioning of the system, it is advisable to test the set-up first
using a short CAT5e/6 cable.
1.
Connect the HDMI source to the MegaView 251 Pro transmitter [4], using a High
Speed HDMI
2.
Optional: To continue viewing the HDMI feed in this room as well, use a High
Speed HDMI
OUT"[3]on the transmitter.
3.
Connect the MegaView 251 Pro receiver to the display or projector [9] using a
High Speed HDMI
4.
Use one CAT5e/6 Ethernet cable to connect the MegaView 251 Pro transmitter[2]
to the receiver [8].
Please note: The MegaView 251 Pro cannot be connected to an existing home
network (LAN), this may cause damage to the device.
5.
Connect the power adapter [?] to the 'DC 24V' connection on the MegaView 251
Pro and plug the adapter into a power socket. The MegaView 251 Pro supports
bi-directional Power-over-Cable (PoC). This means that you can either connect
the power adapter to the transmitter or to the receiver. This eliminates the need
for two power adapters.
Please note: Do not place the MegaView 251 Pro transmitter or receiver in an
enclosed space, such as a TV cabinet or equivalent. Provide adequate ventilation to
ensure that the product is functioning properly and to protect against overheating.
4
1
2
1
8
certified cable.
®
®
certified cable to connect a display to the HDMI port marked "HDMI
certified cable.
®
transmitter
3
4
5
6
reciever
9
10
11 12
®
certified
7
7
© MARMITEK
Publicidad
