Marmitek MegaView 251 Pro Manual De Instrucciones página 5

Using the infrared return function
The MegaView 251 Pro has a built-in "infrared return channel", which allows you to
operate the connected source device from another room where the display is located.
1. Connect the IR receiver to the MegaView 251 Pro receiver [11].
2. Position the IR receiver in such a way it is visible to your infrared remote control,
allowing it to receive the transmitted commands (up to 8 metres).
3. Experiment to find the right position before definitive attachment of the IR
receiver.
4. Connect the IR extender cable to the MegaView 251 Pro transmitter [6].
5. Ensure that the IR extender cable's LED is stuck precisely on the A/V device's
infrared sensor (this can be extremely accurate on some devices). The exact
position can easily be located by shining a torch on the front panel and looking for
the IR sensor window.
6. Experiment to find the right position before definitive attachment of the IR
receiver.
Please note: The adhesive strips may cause discoloration on certain surfaces or may
leave adhesive residue when removed.
The MegaView 251 Pro supports two-way IR passthrough. This feature allows you to
also operate an IR device on the receiver side.
7. Connect the IR receiver to the MegaView 251 Pro transmitter [5].
8. Connect the IR extender cable to the MegaView 251 Pro receiver [12].
9. Ensure that the IR extender cable LED is stuck precisely on the A/V device's
infrared sensor (this can be extremely accurate on some devices). The exact
position can easily be located by shining a torch on the front panel and looking for
the IR sensor window.
Connecting analogue audio
The build-in audio de-embedder can be used to connect the MegaView 251 Pro to a
separate analogue audio system. Use a 3.5 mm stereo mini-jack cable to connect the
MegaView 251 Pro receiver audio port [?] to the analogue audio system.
Please note: to use the audio de-embedder function, the audio output format on the
HDMI source device must be set to PCM.
Using the product
1. Switch on the HDMI source device connected to the MegaView 251 Pro
transmitter.
2. Switch on the display device and select the input connected to the MegaView 251
Pro receiver.
3. You will now receive the video from the connected A/V device.
4. Using the infrared return function, you can operate the HDMI source device.
MegaView 251 Pro 5