Kingfisher CL5ZFXLK90 Manual De Instrucciones página 97

IMPORTANT: The extraction rate of the hood will vary based upon the total
power output selected on the hob, as shown in the table below.
Each hob cooking zone has a maximum rated output of 10 comprising 1-9 and
Boost (10).
Speed Level of the Hood
Speed 1
Speed 3
Speed 5
Speed P – Boost
NOTE: Speed 2 and Speed 4 on the hood are not available when using this function.
If the hood controls are manually overridden when the hob and hood are linked, the hood will operate for five
minutes on this manual setting before returning to control by the hob.
To reconnect the hood and hob immediately, press the Timer
12 Stopping the connectivity function
1. Touch the connectivity key
reconnect again, press the connectivity key
2. If the hob is switched off, the hood will continue to operate independently in Timer mode and the current
speed will flash. The current speed level of the hood will continue for 5 minutes and step down for 2
minutes at each level until finally switching off.
Troubleshooting
Problem
The induction hob
cannot be turned on.
The touch controls are
unresponsive.
The touch controls are
difficult to operate.
5059340445816_MNL_IN_V02.indb 96 5059340445816_MNL_IN_V02.indb 96
Combined Power Output of the Hob
This speed will be selected when there are no more than two cooking zones
in use, and the combined output is 8 or less. For example, zone 1 is on 2,
and zone 2 is on 5.
This speed will be selected when there are no more than three cooking
zones in use, and the combined output is between 9 and 24. For example,
zone 1 is on 7, zone 2 is on 6 and zone 3 is on Boost (10).
This speed will be selected when more than 3 cooking zones are in use,
or the combined output is between 25 and 35. For example, zone 1 is on 7,
zone 2 is on 7, zone 3 is on 6 and zone 4 is on Boost (10).
This speed will be selected when more than 3 cooking zones are in use, and
combined output is 36 or higher.
on the hob, the indicator light will go out and the link will be dropped. To
on the hob again.
Possible cause
No power.
The controls are locked.
There may be a slight film of water over
the controls or you may be using the
tip of your finger when touching the
controls.
and Light together.
Solution
Make sure the induction hob is
connected to the power supply and that
it is switched on. Check the consumer
unit to ensure the RCD has not tripped.
Check whether there is a power cut by
trying other electric appliances.
Unlock the Child Lock (see the Use
section).
Make sure the touch control area is
dry. Use the ball of your finger when
touching the controls.
96
20-06-2022 13:11:39 20-06-2022 13:11:39