Publicidad
Idiomas disponibles
Idiomas disponibles
GB
2. Slide the mains connection cable
holder (5) from top to bottom along the
guide of the device housing.
3. Slide the lance holder (11) from top to
bottom along the guide of the device
housing.
A
Preparation
Risk of injury due to uninten-
tional start-up.
Do not insert the mains plug into
the socket until the machine is
fully prepared for use.
Attaching the high-pressure
hose
1. Connect the high-pressure hose
connection (14) to the water connec-
tion (13) on the device.
2. Hand-tighten the coupling nut of the
high-pressure hose connection (14).
3. Connect the other side of the high-pres-
sure hose connection (2) to the high-
pressure gun (1). The high-pressure
hose connection (2) clicks into place.
Remove the high-pressure hose (3) from
the high-pressure gun (1), see "Ending
the operation".
Locking the high-pressure gun
Risk of injury due to high-pres-
sure jet!
Lock the switch lever (20) every
time work is interrupted.
Make sure that the switch lever
(20) is locked before assembling
or disassembling the device.
Locking
Press the switch lock (21) to the left.
24
Open
Push the switch lock (21) to the right.
Establishing a water supply
Requirements
•
Use a standard garden hose for the
water supply and make sure it is long
enough.
•
A domestic water connection with a
system separator and pump capacity
of at least 450 l/h.
System separator
A system separator (check valve) prevents
the backflow of water and cleaning agent
into the drinking water pipeline.
According to current regulations,
the pressure washer must never
be connected to the drinking water
network without a system separa-
tor. A suitable system separator
must be used in accordance with
EN 12729 Type BA
•
Water that has flowed through a
system separator is classified as non-
potable.
•
System separators are available from
specialist dealers.
Connecting the water supply
Fitting the quick connector to the gar-
den hose:
1. Unscrew the coupling nut from the
quick connector (22)
2. Connect your garden hose to the quick
connector (22) fitting.
3. Hand-tighten the coupling nut.
Publicidad
