Attaching the garden hose:
Make sure that the pressure washer is
always fitted with a filter (8). The filter (8)
is behind the water connection for the gar-
den hose (9).
1. Connect your garden hose to your do-
mestic water connection.
Bleeding the garden hose:
2. Turn on the tap.
Let the water flow out of the garden hose
until the water is bubble-free.
3. Turn off the tap.
4. Using the quick connector (22), con-
nect the garden hose to the water con-
nection (9) on the device.
Mains connection
The pressure washer you have purchased
is already equipped with a mains plug.
The device is intended for connection to
a 230 V~ 50 Hz earthed socket with a re-
sidual current device.
Do not start up the machine until
all the above points have been ob-
served.
Connecting the mains plug:
1. Ensure that the pressure washer is
switched off with the On/off switch (10).
2. Insert the mains plug in the socket:
Select the attachment
Foam nozzle (15):
For applying cleaning agents. See "Clean-
ing with the foam nozzle (15)".
Turbo dirt miller (16):
The rotating water jet is suitable for work-
ing with low water consumption.
Standard Vario nozzle (17):
The adjustable Vario fan jet is particularly
suitable for surface cleaning. The nozzle
includes a high and low pressure setting.
⭯ Narrow jet; spot jet
If you turn the nozzle tip to the left you will
decrease the width of the jet.
⭮ Wide jet
If you turn the nozzle tip to the right you
will increase the width of the jet.
⭪ Low pressure
Pull the nozzle tip forwards.
Maintain a jet distance of at least
30 cm when cleaning painted
surfaces to avoid damage.
⭬ High pressure
Push the nozzle tip back.
Fitting and removing
attachments
Before fitting/removing an at-
tachment, make sure that the
switch lever (20) is blocked by
the switch lock (21). See "Lock-
ing the high-pressure gun"
Fitting attachments:
1. Fit the lance (12) or the foam nozzle
(15) by pushing it in. The insert clicks
into place. Simultaneously press and
turn ⭯ (bayonet lock) the high pres-
sure gun (1).
GB
25