Dometic ACC3100D Instrucciones De Montaje página 9

3. Drill out the corners.
NOTICE! Damage hazard
Ensure that no electrical power cables are damaged. Check where the electrical cables are located.
4. Carefully cut out the opening on the roof using a keyhole saw or a similar tool.
5. Check whether the roof hole needs reinforcing.
Note The edges must be parallel to each other.

1.
6. If needed, remove the foam according to the width of your reinforcing rails (not in scope of delivery).
7. Fit the reinforcing rails.
Installing in an existing opening
1. Remove all screws and fixtures of the existing roof hatch or device.

B
2. Take out the roof hatch or device.
3. Remove the sealant around the opening using a scraper or similar tool.
Installing optional accessories (depending on the model)
NOTICE! Damage hazard
• Observe the correct installation sequence before making the electrical connections.
• Observe the installation manuals of the accessories (optional).
A
2.
1.
W
2.
W
W
W
3.
EN
9