Toshiba TCB-IFDDC201E Manual Del Usuario página 26

 Dx-coil interface configuration
The DN 11 (Capacity Code) setting is needed, and follow the following procedure
Basic procedure for changing settings
Procedure 1
A wired remote controller connect to Terminal A/B of Dx-coil controller.
And set up SW3 bit1 located on the TX-TOS1413, to "OFF" as
following :
Basic procedure for changing settings (go to procedure 2 to 7)
If you want to connect a wired remote controller for Maintenance and
Service. Please set up SW3 bit1 "OFF".
25-EN
SW3 bit-1
If you continuously connect
a wired remote controller?*
NO
Procedure 8
Set up SW3 bit1 "ON" as following :
Complete Dx-coil interface configuration
OFF Wired Remote Controller connected (Default)
ON No Wired Remote Controller
YES
* Once installed the Dx-coil interface does not need to have a remote controller
connected, however it is useful for fault finding and operation status.
Thus, the connection of the remote controller is recommended.
SW3 bit-1
OFF Wired Remote Controller connected (Default)
ON No Wired Remote Controller
– 25 –
1 2 3 4
→ → →
(
Function
Complete Dx-coil interface configuration
Function
5 6 7
→ → →
).