Zodiac RF 5400 iQ Guia De Inicio Rapido página 8

Remove
the cleaner from the water
•
At the end of the cleaning cycle, the cleaner stops at
the foot of a wall.
Fasten the hook to
1
the end of a pool
pole (not included).
2
Hook onto the
handle of the
cleaner using the
hook fastened
to the pole and
lift the cleaner to
the surface.
3
3
Completely
remove the
cleaner from
the water by
the handle.
•
The cleaner can be removed mid-cycle using the pole.
The cleaner will stop automatically as soon as it is out of
the water.
Clean
6
the filter
Fine debris
filter
Very fine
debris filter
1
Open. Remove the filter.
2
Separate the two parts of the filter from one
another.
3
Rinse carefully.
•
Use the fine debris filter (black filter) only on first
use or when removing for winterising.
Recharge
7
the cleaner
Handle Handle
1
Allow the cleaner to dry before charging.
2
Put the cleaner back onto the charging
station after each use.
•
Charging stops automatically as soon as
the cleaner is fully charged. There is therefore
no need to unplug the charging station or
remove the cleaner.
•
It takes between 3 to 4 hours to fully charge
the cleaner.
•
The charge plates must be cleaned
regularly using a cloth or the scouring side of
a kitchen sponge and fresh water.
•
Do not leave the cleaner drained of charge.
•
Make sure the cleaner is fully charged
before winterising.
8
Rear
Rear
grating grating
EN
Bip Bip