Programmed Play - Aiwa XR-MR5 Manual De Instrucciones

PROGRAMMED PLAY

Up to 30 tracks can be programmed from the loaded disc.
Use the remote control.
1 In stop mode, press PROGRAM while pressing SHIFT
so that "PRGM" appears on the display.
2 Press the numbered buttons and +10 to program
a track.
Example:
To select the 12th track, press +10 and 2.
To select the 20th track, press +10, +10 and 0.
Selected track
number
Total number of
selected tracks
3 Repeat step 2 to program other tracks.
4 Press c to start play.
To check the program
Each time g is pressed in stop mode, a track number and
program number will be displayed.
To clear the program
Press s in stop mode.
The program is also cleared when you open the disc compartment.
To add tracks to the program
Before playing, repeat step 2. The track will be programmed after
the last track.
• If you attempt to program more than 30 tracks, "PRGM FULL" is
displayed.
To change the programmed tracks
Clear the program and repeat all the steps again.
Program number
Total playing time of the
selected tracks
NOTE
• During programmed play, you cannot select the tracks directly
with the numbered buttons or perform random play.
• In the following cases, the total playing time of programmed tracks
is displayed as "--:--", which means you cannot check the total
playing time of programmed tracks, but the programmed tracks
are still registered in memory.
- the total playing time of programmed tracks exceeds 99 minutes
and 59 seconds.
- you selected a track having a track number 31 or higher
• Repeating programmed play is also possible.
• The remaining time of play cannot be displayed while performing
programmed play.
En
15
ENGLISH