Publicidad
Idiomas disponibles
Idiomas disponibles
C
Using the appliance
NOTE:
The following installation procedure must be carried out by a
qualified electrician. For the installation of the feeding cable
carry out the following operations:
- Open the terminal board by inserting a screwdriver into the
side tabs of the power code cover.Use the screwdriver as a
lever by pushing it down to open the cover as below.
- Connect the electricity follows the diagram as printed in
the surface of power code cover.
- Fasten the supply cable in place with the clamp and close
the cover of the terminal board.
18
EN
Publicidad
