PRESIDENT MC KINLEY Manual Del Usuario página 44

squelch level) and from 0 (without anti-vox) to 9 (low level). Default
value: OFF.
- Delay time SET-T: allows avoiding the sudden cut of the transmission
by adding a delay at the end of speaking. The level is adjustable
from 1 (short delay) to 9 (long delay). Default value: 5.
The VOX SETTING automatically activates the VOX function. "VOX"
appears in the display.
Note: The unit will automatically
the setting parameters if no key is pressed after 10 seconds or, if
any key is pressed.
7) SCAN ~ DW ~ M1
SCAN
(short press)
Press the SCAN key (7) to activate
order. "SCAN" is displayed. The scanning stops as a channel is
active. The scanning automatically starts 3 seconds after the end
of the transmission and no key is activated. In
turn the rotary CH knob (5) or use the UP/DN buttons (13) on the
microphone to change scan direction.
During the scan, long press the • key (9) for one second to
between channel scan and memory scan modes. In the MEMORY
SCAN mode, only the emergency channels (see § EMERGENCY
CHANNELS on page 44) and the memorized channels (see §
MEMORY page 45) are scanned.
Press the PTT switch (12) or the SCAN key (7) to
function.
DW
(long press)
A long press (1s) on the DW key (7)
function. "DW" is displayed. This function lets you watch over
emergency and the current channels.
- The first long press activates the DW function between emergency
channel 1 and the current channel.
- A second long press activates the function between the emergency
channel 2 and the current channel. See § EMERGENCY CHANNEL
1 and 2 page 49.
exit VOX SETTING without saving
the SCAN function in ascending
SCANNING mode,
alternate
exit the SCAN
activates the DW (Dual Watch)
The current channel number and the emergency channel are
displayed alternately. The "EMG" icon also appears along with
the emergency channel. The selected channel can be changed
during dual watch.
- A new long press of the DW key (7)
"DW" disappears from the display.
M1
See § MEMORY page 45.
8) ANB/ANL ~ HI-CUT ~ EMERGENCY CHANNELS ~ M2
ANB/NL
(short press)
ANL/NB (Automatic Noise Limiter / Noise Blanker): These filters
reduce background noise and some noise on reception.
Press the ANL/NB key (8) to
states in a loop: 1. ANL/on - NB/off • 2. ANL/off - NB/on • 3. ANL/
on - NB/on • 4. ANL/off - NB/off.
The filter icon appears in the display when the filter is active (on).
HI-CUT
(long press)
Hi-Cut cuts out the high frequency interferences.
Press the HI-CUT key (8) for one second to
HI-CUT filter. «HI-CUT» appears in the display when the filter is
active.
EMERGENCY CHANNELS
- Briefly press the • key (9) then the •EMG (8) key to combine these
two keys.
activates
- A first combination
- A second combination
- When an emergency channel is active, «EMG» is displayed.
- A third combination allows to
disappears from the display.
See § EMERGENCY CHANNEL 1 and 2 pages 49.
M2
See § MEMORY page 45
44
deactivates the DW function.
alternate between the following 4
activate/deactivate
(9 + 8 short press)
emergency channel 1.
activates
emergency channel 2.
return to the initial channel. «EMG»
the