Technical Characteristics; Trouble Shooting; How To Transmit Or Receive A Message - PRESIDENT MC KINLEY Manual Del Usuario

E) TECHNICAL CHARACTERISTICS
1) GENERAL
- Channels
- Modulation modes
- Frequency ranges
- Antenna impedance
- Power supply
- Dimensions (W x D x H)
- Weight
- Accessories supplied
2) TRANSMISSION
- Frequency allowance
- Carrier power
- Transmission interference
- Audio response
- Emitted power in the adj.
channel
- Microphone sensitivity
- Drain
- Modulated signal distortion
3) RECEPTION
- Maxi. sensitivity at 20 dB
sinad
- Frequency response
- Adjacent channel selectivity : 60 dB
- Maximum audio power
- Squelch sensitivity
- Frequency image rejection
rate
- Intermediate frequency
rejection rate
- Drain
: 40
: AM / FM / USB / LSB
: from 26.965 MHz to 27.405 MHz
: 50 ohms
: 13.8 V / 27.6 V
: 172 (W) x 150 (D) x 52 (H) mm
: 1 kg
: microphone UP/DOWN with
support, mounting cradle, screws and
fused power cord.
: +/- 300 Hz
: 4 W AM/FM - 12 W USB/LSB
: inferior 4nW (- 54 dBm)
: 300 Hz to 3 KHz in AM/FM/LSB/USB
: Inferior to 20 µW
: 3 mV
: 3 A (with modulation)
: 1.8 %
: 0.5 µV - 113 dBm (AM/FM)
0.28 µV - 118 dBm (USB/LSB)
: 300 Hz to 3 kHz in AM/FM
: 3 W
: minimum 0.2 µV - 120 dBm
maximum 1 mV - 47 dBm
: 60 dB
: 70 dB
: 400 mA nominal / 1000 mA maximum
F) TROUBLE SHOOTING
1) YOUR CB RADIO WILL NOT TRANSMIT OR YOUR
TRANSMISSION IS OF POOR QUALITY
- Check that the antenna is correctly connected and that the SWR
is properly adjusted.
- Check that the microphone is properly plugged in.
- Check that the RF POWER bargraph is set on maximum.
- Check that the MIC GAIN bargraph is set on maximum.
2) YOUR CB RADIO WILL NOT RECEIVE OR RECEPTION IS
POOR
- Check that the RF GAIN bargraph is set on maximum.
- Check that the squelch level is properly adjusted.
- Check that the volume is set to a comfortable listening level.
- Check that the antenna is correctly connected and that the SWR
is properly adjusted.
3) YOUR CB WILL NOT LIGHT UP
- Check the power supply.
- Check the connection wiring.
- Check the fuse.
G) HOW TO TRANSMIT OR RECEIVE A MESSAGE
Now that you have read the manual, make sure that your CB
Radio is ready for use (i.e. check that your antenna is connected).
Press the "push-to-talk" switch and announce your message "At-
tention stations, transmission testing" which will allow you to check
the clearness and the power of your signal. Release the switch
and wait for a reply. You should receive a reply like, "Strong and
clear".
If you use a calling channel (19) and you have established commu-
nication with someone, it is common practice to choose another
available channel so as not to block the calling channel.
51