Sony HT-BE1 Manual De Instrucciones página 9

Installing the satellite speakers on the wall
1
Remove the screw at the bottom of the
speaker.
2
Turn the speaker stand opposite 180˚,
and then lightly tighten the screw.
Note
Do not turn the speaker stand more than 180˚.
The cord may become disconnected.
3
Tighten the screw again after adjusting
the angle of the speaker.
4
Install the speaker on the wall.
Install screws (not supplied) in the wall
and mount the satellite speaker by the
hollow for the screw in the bottom of
speaker. You can adjust the angle of the
satellite speakers by selecting the hollow
on the speaker.
The middle hollow is used to attach the
speaker straight on the wall. The right or
left hollow is used to attach the speaker
on the wall at an angle.
Notes
• When you loosen or tighten the screw at the bottom of the speaker, use an appropriate driver.
• Be sure that the cord between the satellite speaker stand and the speaker is not pinched.
• If you install the speaker to a wall, make sure the wall you install to is strong enough. Since the speaker is
heavy, it is dangerous if it falls. Sony cannot take any responsibility for any injury or damage during
installation of those speakers.
Downloaded from: https://www.usersmanualguide.com/
continued
GB
9