Publicidad
Idiomas disponibles
Idiomas disponibles
NOTICE
THIS PRODUCT IS EQUIPPED WITH AN INSTANT HEAT CIRCUITRY.
STATE-OF-THE-ART TECHNOLOGY ALLOWS THE HEATER TO
REACH THE OPERATING TEMPERATURE IN LESS THAN ONE
MINUTE.
DO NOT LEAVE PRODUCT ON OR PLUGGED IN WHILE NOT
IN USE. UNIT WILL BURN OUT IF POWER IS KEPT ON FOR AN
EXTENDED PERIOD OF TIME. WARRANTY WILL BE VOIDED. TURN
UNIT OFF AND UNPLUG WHEN NOT IN USE.
USER MAINTENANCE
Your iron is virtually maintenance free. No lubrication is
needed. Keep all vents and openings clear of dirt and dust.
If cleaning becomes necessary, disconnect the unit from the
power source, let it cool and wipe exterior with a cloth. If any
abnormal condition occurs, unplug the unit, allow it to cool,
and return it for repair to an authorized service representative
only. No repairs should be attempted by the consumer.
CAUTION
NEVER allow the power-supply cord to be pulled or twisted.
Never wrap the cord around the unit. Damage will occur at the
high flex point of entry into the unit, causing it to rupture and
short circuit. Inspect the cord frequently for damage. Stop use
immediately if damage is visible or if unit stops or operates
intermittently.
STORAGE
When not in use, your appliance is easy to store. Allow unit to
cool, then simply put back in the box, and store out of reach
of children in a safe, dry location. Do not jerk or strain cord at
plug connections.
BCI005UC IB-17590A.indd 13-14
BCI005UC IB-17590A.indd 13-14
FEDERAL COMMUNICATIONS
COMMISSION NOTICE
WARNING: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must accept
any interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for
help.
2022/8/17 12:10 PM
2022/8/17 12:10 PM
Publicidad
