Publicidad
Idiomas disponibles
Idiomas disponibles
5.
Operation
5.1.
Switching on/off the cabin light.
1.
Press the button A.
.
The cabin light goes on and the respective symbol appears in the display.
The cabin light can also be switched on when the master switch is off (e.g. for cleaning
the cabin).
5.2.
Setting the time and water hardness
Setting the time
1.
Switch off the control unit via the master switch.
2.
Hold down the
.
The time and the service symbol flash in the display.
3.
Set the time using the up/down
.
Each press of the button changes the value by 1 minute. If the button is held down for a
prolonged period, the value will change more quickly.
4.
Confirm the set value using the
.
The time stops flashing and the two digits for the water hardness setting begin to flash.
Setting the water hardness
'
The procedure for setting the time (steps 1 to 4) must first have been completed or ended.
5.
Set the water hardness using the up/down buttons
.
The setting range lies between 0 and 30 °dH. Ask responsible waterworks for the water hardness
in your area.
6.
Confirm the set value using the
.
The display stops flashing. The control unit goes into standby mode. The time appears in the
display.
5.3.
Switching on/off standby mode
1.
Press the master switch on the left side of the housing.
.
When the master switch is switched on, the control unit is in standby mode and can be
operated via the control panel. The time appears in the display.
Master switch
PAGE 10
button and simultaneously switch on the master switch.
buttons.
button.
button.
Button:
Description:
A Cabin light button
B Operating mode button
C Left/Right buttons
D Up/Down buttons
E OK button
.
Control panel
SANARIUM C
5070188/07.02
Publicidad
