Publicidad
Idiomas disponibles
Idiomas disponibles
SANARIUM C
5.
Operation
5.6.
Ending a program
Bathing or preselection mode (Sauna or SANARIUM) can be ended during the ongoing program.
1.
The control unit ends the program automatically at the end of bathing duration
or
2.
To end the bathing program ahead of time – press the B button until END appears in the display.
.
The bathing program ends automatically three seconds after the last press of a button. The control
unit goes automatically into standby mode. The time appears in the display.
3.
After a bath in the SANARIUM it is required to drain the unused water out of the water tank and
the evaporator system for reasons of hygiene.
'
See Chapter 5.9. - Putting the evaporator out of operation.
The bathing program used last is saved at the end of the program.
After the bathing programs are called using the B button, the control unit shows the
bathing program used most recently first.
Automatic subsequent drying program after SANARIUM operation
D
After bathing operation, the air vent in the cabin must be engaged in position 4 if an air vent outlet
is installed.
.
If the SANARIUM was in operation for more than 10 minutes, the subsequent drying program is
started at the end of the program automatically. In this case the dryer symbol
the display. The remaining time for the subsequent drying program appears in the right digital
display together with the hour glass symbol .
.
The heater heats up again, this causes increased ventilation. The cabin is ventilated by these
measures.
.
At the end of the subsequent drying program the control unit goes into to standby mode
automatically. The time appears in the display.
Airing the cabin after sauna operation or the subsequent drying program
D
After sauna operation or after the end of the subsequent drying program open the cabin door for
a while!
5070188/07.02
Button:
Description:
A Cabin light button
B Operating mode button
C Left/Right buttons
D Up/Down buttons
E OK button
will appear in
PAGE 13
Publicidad
