Senix GTBCU4QL-M Manual Del Operador página 16

4. If you find that parts are missing or show damage do
not use the product, please call 1-800-261-3981 for
assistance. Using an incomplete or damaged product
represents a hazard to people and property.
5. Ensure that you have all the accessories and tools
needed for assembly and operation. This also includes
suitable personal protective equipment.
WARNING:
Wear protective gloves for this assembly work
and always lay the product on a flat and stable
surface while assembling.
Follow the assembly instructions step-by-step
and use the pictures provided as a visual guide
to easily assemble the product!
WARNING:
To prevent an accidental start that could cause
serious personal injury, always disconnect the
engine spark plug wire from the spark plug when
assembling parts.
Never install, remove, or adjust any attachments
while power head is running. Failure to stop the
engine can cause serious personal injury.
INSTALLING THE CUTTING HEAD
SHIELD
1. Remove the screw from the cutting head shield.
2. Insert the tab on the mount bracket into the slot in the
cutting head shield (Fig. 2).
3. Rotate the cutting head shield until the hole on the
mount bracket aligns with the screw hole on the cutting
head shield.
4. Insert the screw and tighten until the cutting head shield
is firmly in place.
CHANGING THE CUTTING HEAD
TO THE CUTTING BLADE
1. Unscrew and detach the cutting head.
2. Insert a tool so the mounting disc does not move. Install
the blade, washer, concave to be upwards, and the
floating disc (Fig. 3).
NOTE:
The pit side of washer must be contacted with the blade.
3. Screw down the locknut and tighten it counterclockwise
by the socket spanner.
EN - 16
4. Remove the socket spanner and the wrench and check
for freedom of motion of the blade.
CHANGING THE CUTTING BLADE
TO THE CUTTING HEAD
1. Insert a tool so the mounting disc doesn't move.
2. Loosen the looknut and remove the floating disc,
washer and the cutting blade.
3. Attach the cutting head to the mounting disc (Fig.4).
3. Check for secure installation.
INSTALLING THE HANDLE
1. Align and screw upper fixed cover and the handle
support.
2. Lock two screws between lower fixed cover and handle
support until the tube is are firmly in place (Fig. 5).
INSTALLING/REMOVING THE
LOWER SHAFT ATTACHMENT
In addition to the supplied line trimmer lower shaft, the
coupler on the upper shaft enables the use of various other
lower shaft attachments, available for separate purchase.
WARNING:
Before using any attachment, read and
understand the manual that came with the
attachment. Follow all safety information
contained within.To avoid serious personal injury
and damage to the unit, shut the unit off before
removing or installing an attachment.
To intsall:
1. Set the unit on a flat, level surface.
2. Loosen the coupler knob (Fig. 6).
3. Align the locating button on the lower shaft with the
locating hole of the coupler (Fig. 7).
4. Then insert the lower shaft (Fig. 8).
5. Pull the lower shaft to check if it is frimly in place.
6. Tighten the knob for securing (Fig. 6).
To remove:
1. Set the unit on a flat, level surface.
2. Loosen the coupler knob.
3. Press and hold the release button.
4. Pull the lower shaft attachment straight out of the
coupler.
WWW.SENIXTOOLS.COM