Publicidad
Idiomas disponibles
Idiomas disponibles
attachment is properly installed
and securely fastened. Be sure
the cutting attachment shield
is properly attached and in the
position recommended by the
manufacturer. Use only flexible,
nonmetallic line recommended
by the manufacturer. Never use,
for example, wire or wire-rope,
which can break off and become
a dangerous projectile.
4. DO NOT USE any attachment
with this power head other than
the ones recommended by the
manufacturer. Serious injury to
the operator or bystanders could
result as well as damage to the
machine.
5. The handles shall be mounted
in accordance with the
manufacturer's instructions.
Do not attach any blade to a
unit without proper installation
of all required parts. Failure
to use the proper parts can
cause the blade to fly off and
seriously injure the operator and/
or bystanders. Discard blades
that are bent, warped, cracked,
broken, or damaged in any way.
Use a sharp blade. A dull blade
is more likely to snag and thrust.
6. Keep the handles free from oil
and fuel.
WWW.SENIXTOOLS.COM
7. Do not operate the unit in
insufficient lighting conditions.
8. Do not operate this unit when
tired, ill, or under the influence of
alcohol, drugs, or medication.
9. Always use proper handles when
trimming.
10. Do not smoke while filling tank.
11. Do not fill fuel in an enclosed
room or near open flames.
Ensure adequte ventilation.
12. Always store fuel in a properly
marked container that is
approved by local codes and
ordinances for such usage.
13. Never remove the fuel tank cap
while the engine is running.
14. Do not operate the unit inside
a closed environment, such as
a room or building; breathing
carbon monoxide from exhaust
fumes can kill.
15. Never attempt to make engine
adjustments while the unit is
running. Always make engine
adjustments with the unit resting
on a flat, clear surface.
16. Do not use the unit if it is
damaged or poorly adjusted.
Never remove the unit's guard.
Serious injury to the operator or
bystanders could result as well
as damage to the machine.
17. Clear the area to be cut before
9 - EN
Publicidad
