Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly and Installation
3. Shut the bracket (Figure 3) and tighten it with the previously removed screw (Figure 4).
Apply this to each side.
4. Make sure that the footrest is correctly installed. Grab the footrest and move it manually
a few times from the bottom to the top. If you do not notice anything abnormal, the
footrest is installed correctly.
3
INSTRUCTIONS FOR REMOVAL AND USE OF HEAD CUSHION AND BACKREST
The use of the head cushion can reduce the intensity of kneading massage on the neck and
shoulders. You can decide whether to use the head cushion according to your own needs
(the head cushion is recommended). The backrest and the back cushion are connected by a
zipper (1). The head cushion and the backrest are connected by a hook-and-loop fastener (2).
Zipper
1
48
4
Hook-and-loop
fastener
2
Assembly and Installation
FLOOR PROTECTION
The prolonged heavy pressure of the massage chair may cause scratches on the floor.
Thus, put a carpet or cushion on the floor where the massage chair is placed to avoid this
damage.
NOTE:
Do not move the massage chair with its wheels on the rough ground or in a narrow
space.
INSTRUCTION FOR MOVEMENT
Ensure that no cables are on the floor. Tilt the backrest backwards to a certain degree
(whereby its centre of gravity remains on the wheels), push the chair forwards or back-
wards with your hands and finally return it slowly and gently to its basic position.
NOTE:
Before you move the chair, you have to switch off and disconnect the power and
connecting cables.
NOTE:
Please move the chair with at least two persons. One person should lift the chair from
the front in order to place it on its wheels!
49
Publicidad
