Publicidad
1b
2
2a
12
All manuals and user guides at all-guides.com
2. Installation of the machine
2.1 Installation
The tire changer can be installed on any concreted fl oor
or on any fl oor covered with a similarly hard fl oor covering.
It is recommended to secure the machine to the
ground at the four points provided with anchor bolts
M10, or with appropriate dowels. Apart from the
property of the fl oor, the Health and Safety at Work
regulations as well as all other national regulations on
the working environment must be taken into account
when choosing site.
For installation on a higher fl oor check rated load of that
fl oor. In general we recommend to consult a construction
expert before any installation on a higher fl oor.
The installation requires an area (A x B, Fig.1b) of at
least: 2200 x 2700 mm.
2.2 Fitting the machine post
WARNING:
THE WORK DESCRIBED BELOW MUST BE DONE
BY A TECHNICIAN AUTHORISED BY THE DEALER.
To optimise the packaging or to guarantee greater
safety during transportation, the machine may be
delivered with some parts disassembled.
Upon receiving the machine, some important parts
may need to be reassembled. Although these are
simple operations, we recommend that you follow the
instructions provided below.
Mounting the vertical column (Fig. 2):
A.
Remove the column base guard "1" and the two lateral
holders (if present) from the machine. Cut and remove
the straps holding the shaped washers "2" in position.
B.
Lift the column "0" with an appropriate lifting tool (crane,
fork lift) and a belt of sufficient capacity (200 kg). A
second person is required to help with this operation. BE
CAREFUL NOT TO DAMAGE THE AIR HOSES "3". Insert
the air hose through the hole "H" in the cabinet.
C.
WARNING: Before inserting the column fi xing pin
"4", grease and position the shaped washers "2", as
illustrated. Insert the column in its seat, then fi t the pin
"4", the two tapered bushings "5", the washers "6" and
the nuts "7". Tighten the nuts evenly on both sides and
manually fi nish tightening until the tapered bushings
are locked in the seats.
IMPORTANT!
THEN TIGHTEN THE NUTS "7" WITH A TIGHTENING
TORQUE OF 90 N/m.
D.
Tilt the column backwards. Pull the rod "8" of the tilting
cylinder and connect it to the column with the pin "9". Apply
N°243 Loctite to the grub screw "10" and tighten with a
tightening torque of 11 Nm.
[For previous version: Lock pin "9a" with the split pin "10a"].
E.
Remove the left side of the machine and attach air
hose "3" (tool movement) to the pedal assembly
connector "11".
Publicidad
