American Standard SAVER AM00495 400 Serie Instrucciones De Instalación página 5

2
FITTING FRAME ASSEMBLY INTO OPENING
2 PEOPLE REQUIRED
Place completed frame onto the tub marked edge
at the edge of the at surface of the deck. Push
wall posts against wall and position the posts with a
level and mark the mounting holes on the wall. (Ref. 1)
Remove the frame; drill 1/8" holes at marked locations.
(Ref. 2)
Use the anchors if NOT securing to studs
(use 1/4" drill bit). (Ref. 3)
Remove frame and proceed to STEP 3.
MARKED HOLES
1
Mark holes
DO NOT install screws
3
FITTING FIXED GLASS PANEL INTO FRAME ASSEMBLY
*if not previously installed onto Fixed Door Post!
RIGHT-HAND FIXED PANEL SHOWN. SEE PAGE 8 FOR
LEFT-HAND INSTALLATION.
2. Slide Fixed Glass Panel (14) in place, engaging Top and
Bottom Horizontal Rails and Door Post
3. Install top & bottom Retaining Blocks with screws (11) to hold Fixed Door
Panel in place.
NOTE: Hand tighten screws. Do not over tighten!
4. Install Fixed Door Water Deflector (24) by pressing into place. Wet with
water to aid inserting deflector between glass door and door post. Deflector
may need to be trimmed if it extends beyond the top or bottom rail.
1
12
DRILL MARKED INSTALL ANCHOR
LOCATIONS
2 3
Use 1/4" drill bit
for anchor holes
VIEW FROM INSIDE
2
A
IF NEEDED
4
19
5
Installation Range
57-1/2" – 58-1/4"
(1460 – 1480mm)
1
2
3
A
FIG. A
12
14
3
F i x e d Pa n e l
11
View from inside
12
710286-100 Rev. 2 03/2020
23
21
24
21