American Standard SAVER AM00495 400 Serie Instrucciones De Instalación página 7

6
INSTALLING SLIDING DOORS
Hang door in top track as shown in
Depress lower Rollers and seat as shown in
SLIDING DOOR ADJUSTMENTS
The sliding door may require adjustment after being installed and can be checked by fully closing door and check for
vertical alignment as it rests on the Sliding Door Post (7). If Sliding Door Panel does not rest correctly on Sliding Door
Post or there is a gap on one end, the Top Rollers can be adjusted by pulling down the plastic covers marked UP to
reveal the 8mm nut. Slightly loosen the nut with the nut driver enough to move the sliding door, then move the door
slightly up or down, then tighten and check alignment of sliding door when closed. Once sliding door t is correct,
verify all rollers (UP & DOWN) that they are not loose. Tighten if necessary.
1
2
7
ADD DOOR HANDLES AND WATER DEFLECTORS
Screw Handle (5) in place as shown in 1.
Install Water Deflectors (15) as shown in 2A & 2B.
Install Magnetic Seal (8) on Sliding Glass Door (13).
1
2A
Sliding
Door Panel —
Longer Water
➀
NOTE: Roller marked UP installs on TOP Horizontal Rail.
.
➁
. NOTE: If Top & Bottom Rollers need to be reversed, see page 8.)
2B
Fixed Panel —
Shorter Water
7
1
Door Panel
2
2
1
710286-100 Rev. 2 03/2020