Yakima FatCat 4 Instrucciones página 5

REMOvE lIFT BOlT
• Loosen with hex wrench.
• You may need to reposition the mounts
to accommodate Ski Lift.
FatCat 6
Optional
Storage for
hex Wrench:
(inside carrier)
INSTAll SKS lOCKS
Use the inserted key
to install the locks into
the lock housings.
Push the core all the way into the housing.
Hold the core with the tip of your thumb as
you pull out the non-numbered Control Key.
The lock should remain in the housing.
1033545C - 5/18
FatCat 4
ClOSE
CARRIERS
WITh FIRM
PRESSURE
Use a key to dislodge
the black plastic plug
from the lock housing.
On some housings, you
must rotate the moving
parts behind the housing.
ROTATE
lIFT dOWN
TOWARd
MOUNTING
BRACKET
vERIFy
ThE
ClOSURE!
Insert the non-numbered
Control Key into the lock core.
IMPORTANT
You may need to rotate the small hole inside the lock
housing so that the point on the lock core will align.
ATTACh lIFT
TO MOUNTING
BRACKET
• Use lift bolt
(Step 20).
• Tighten lift bolt
completely.
• Re-tighten the
front base screw.
• Verify closure of carrier by
pulling upward on skis.