Evh ICONIC Serie Manual De Instrucciones página 2

EVH® 5150 ICONIC® 6L6 15-WATT 1x10 COMBO EVH® 5150 ICONIC® 6L6 15-WATT 1x10 COMBO
The 5150 Iconic tube amplifier series is designed to capture
many of Edward Van Halen's iconic guitar tones in a single
amplifier. These simple and easy-to-use two-channel tube
amplifiers accomplish many tonal variations from the EVH
5150III® series, as well as adding some heavier classic 5150®
flavors using the overdrive and burn tone switches on chan-
nels one and two respectively. Many modern gig-friendly
A. INPUT: Plug in an instrument here. Use only a high-qual-
ity shielded instrument cable.
B. CHANNEL ONE/TWO SELECT: Latching pushbutton
alternately selects channel one (low-medium gain, green
LED) and channel two (high gain, red LED). Footswitch
overrides this switch when connected to amplifier.
C. CHANNEL ONE GAIN: Preamp gain control for low-
medium gain channel one. Higher settings increase pre-
amp distortion.
D. OVERDRIVE SELECT: Presets gain and resets voicing in
channel one from clean to medium distortion tone.
E. CHANNEL TWO GAIN: Preamp gain control for high-
gain channel two. Higher settings increase preamp
distortion and automatically increase noise reduction
setting.
features have also been added, including built-in noise
reduction on channel two, effects loop, front-panel reso-
nance and presence controls, a quarter-power switch, an
included footswitch for selecting channels, and an analog-
speaker-emulated headphone output that can also be used
for silent recording.
CONTROL PANEL CONTROL PANEL
F. BURN SELECT: Presets gain and resets voicing in chan-
nel two from high gain to heavier and thicker distortion
tone.
G. LOW/MID/HIGH EQ: Shared passive low-, middle- and
high-frequency tone controls.
H. CHANNEL ONE/TWO VOLUME: Post-preamp volume
controls for each channel. Note: For cleaner sound from
channel one, set this volume control higher and keep
channel one gain control (C) at lower settings.
I. REVERB: Adjusts reverb level for both channels (post
effects loop).
J. RESONANCE: Adjusts power amp low-frequency
response by selectively adjusting damping factor.
K. PRESENCE: Adjusts ultra-high frequency tone control for
both channels by selectively adjusting damping factor.
1