Install The Battery Pack; Remove The Battery Pack; Operation; Start The Machine - GreenWorks BLF346 Manual Del Operador

You can use the nozzle to increase airflow in tight
areas.
9.3

INSTALL THE BATTERY PACK

Figure 3.
WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the engine stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
9.4

REMOVE THE BATTERY PACK

Figure 3.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
10

OPERATION

WARNING
Make sure the blower tube is in position before
operation.

10.1 START THE MACHINE

Figure 4.
1. Pull the trigger to start the machine.
2. Pull the trigger fully to increase the speed.
3. Release the trigger to decrease the speed.

10.2 STOP THE MACHINE

Figure 4.
1. Release the trigger to stop the machine.
NOTE
Wait until the engine stops after you stop the machine.

10.3 CRUISE CONTROL LEVER

Figure 4.
1. Pull the cruise control lever clockwise to increase
the speed. This will lock the speed at the desired
setting.
English
TIP
2. Push the cruise control lever counter clockwise to
decrease the speed.
If you decrease the speed all the way, the unit will stop
and it is necessary to do the first step again.

10.4 TURBO BUTTON

Figure 4.
1. Push the turbo button, the machine is at the highest
speed.
2. Release the turbo button, the machine is at the
normal speed.

10.5 OPERATION TIPS

• Blow around the outer edge of the unwanted
materials to prevent the unwanted materials from
scattering.
• Use rakes and brooms to clear the unwanted
material before you blow.
• Make the surfaces wet before you clear the
unwanted material in dusty conditions.
• Look out for children, pets, open windows, and
cleaned cars during operation.
•

Clean the machine.

• Discard the unwanted material when you complete
work.
11

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
WARNING
Remove the battery pack from the machine before
maintenance.
11.1 CLEAN THE MACHINE
The machine must be dry. Humidity can cause risks of
electrical shocks.
• Clear the unwanted material out of the air vent with
a vacuum cleaner.
7
NOTE
CAUTION
CAUTION
CAUTION
EN