Install The Tube; Install The Battery Pack; Remove The Battery Pack; Operation - GreenWorks BLM303 Manual Del Operador

WARNING
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.

10.2 INSTALL THE TUBE

Figure 2.
1. Move the tube until the lock button engages into the
slot.
You can use the nozzle to increase airflow in tight
areas.

10.3 INSTALL THE BATTERY PACK

Figure 3.
WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the engine stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.

10.4 REMOVE THE BATTERY PACK

Figure 3.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
11

OPERATION

WARNING
Make sure the blower tube is in position before
operation.
English
TIP

11.1 START THE MACHINE

Figure 4.
1. Pull the trigger to start the machine.
2. Pull the trigger fully to increase the speed.
3. Release the trigger to decrease the speed.

11.2 STOP THE MACHINE

Figure 4.
1. Release the trigger to stop the machine.
Wait until the engine stops after you stop the machine.

11.3 CRUISE CONTROL LEVER

Figure 4.
1. Pull the cruise control lever clockwise to increase
the speed. This will lock the speed at the desired
setting.
2. Push the cruise control lever counter clockwise to
decrease the speed.
If you decrease the speed all the way, the unit will stop
and it is necessary to do the first step again.

11.4 TURBO BUTTON

Figure 4.
1. Push the turbo button, the machine is at the highest
speed.
2. Release the turbo button, the machine is at the
normal speed.

11.5 OPERATION TIPS

• Blow around the outer edge of the unwanted
materials to prevent the unwanted materials from
scattering.
• Use rakes and brooms to clear the unwanted
material before you blow.
• Make the surfaces wet before you clear the
unwanted material in dusty conditions.
• Look out for children, pets, open windows, and
cleaned cars during operation.
• Clean the machine.
• Discard the unwanted material when you complete
work.
7
NOTE
NOTE
EN