Assemble As A Blower; Assemble As A Vacuum; Install The Battery Pack; Remove The Battery Pack - GreenWorks SBL24B00 Manual Del Operador

WARNING
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
10.2

ASSEMBLE AS A BLOWER

Figure 2 - 3.
1. Align the grooves with the tabs in the blower tube.
2. Install the tube onto the blower housing until the tabs
engage the grooves.
3. Turn the tube in the direction of the arrow until the two
tabs lock into the positions.
10.3

ASSEMBLE AS A VACUUM

WARNING
Make sure that the machine is in the OFF position, and the
impellers stop before you attach or remove tubes.
1. Connect the collection bag to the machine in the same
procedures as blower tube.
2. Connect the blower tube to the air vent in the same
procedures as above.
English
10.4

INSTALL THE BATTERY PACK

• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
10.5

REMOVE THE BATTERY PACK

1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
11

OPERATION

Make sure the blower tube is in position before operation.
11.1

START THE MACHINE

1. Pull the trigger (1) to start the machine.
2. Push the trigger to increase the speed.
3. Release the trigger to decrease the speed.
7
WARNING
WARNING
EN