You can use the nozzle to increase airflow in tight
areas.
9.3
INSTALL THE BATTERY PACK
Figure 3.
WARNING
•
If the battery pack or charger is damaged, replace
the battery pack or the charger.
•
Stop the machine and wait until the engine stops
before you install or remove the battery pack.
•
Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
9.4
REMOVE THE BATTERY PACK
Figure 3.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
10
OPERATION
WARNING
Make sure the blower tube is in position before
operation.
10.1 START THE MACHINE
Figure 4.
The machine has a speed button to adjust the air
velocity.
1. Push the on/off button in the 1 or 2 position.
10.2 STOP THE MACHINE
Figure 4.
1. Push the on/off button in the off position.
10.3 OPERATION TIPS
•
Blow around the outer edge of the unwanted
materials to prevent the unwanted materials from
scattering.
•
Use rakes and brooms to clear the unwanted
material before you blow.
•
Make the surfaces wet before you clear the
unwanted material in dusty conditions.
English
TIP
•
Look out for children, pets, open windows, and
cleaned cars during operation.
•
Clean the machine.
•
Discard the unwanted material when you complete
work.
11
MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
WARNING
Remove the battery pack from the machine before
maintenance.
11.1 CLEAN THE MACHINE
The machine must be dry. Humidity can cause risks of
electrical shocks.
•
Clear the unwanted material out of the air vent with
a vacuum cleaner.
•
Do not spray the air vent or put the air vent in
solvents.
•
Clean the housing and the plastic components with
a moist and soft cloth.
12
TRANSPORTATION AND
STORAGE
WARNING
Remove the battery pack from the machine before
tranportation and storage.
12.1 MOVE THE MACHINE
•
Only hold the machine with the handgrip.
•
Remove the blower tube when you move the
machine on a vehicle.
12.2 STORE THE MACHINE
•
Clean the machine before storage.
•
Make sure that the motor is not hot when you store
the machine.
7
CAUTION
CAUTION
CAUTION
EN