Publicidad
Idiomas disponibles
Idiomas disponibles
• Now insert the cuff line into the
connection for the cuff connector.
Adopting the correct posture
• To carry out a blood pressure meas-
urement, make sure you are sitting
upright and comfortably. Lean back
and place your arm on a surface. Do
not cross your legs. Place your feet
next to each other flat on the floor.
• Always make sure that the cuff is at
heart level.
• To avoid distorting the measure-
ment, you should remain as still as
possible during the measurement
and not speak.
Performing the blood pressure measurement
• As described above, attach the cuff and adopt the pos-
ture in which you want to perform the measurement.
• Start the blood pressure monitor with the START/STOP
button
. After the full-screen display, the respective
alarm symbols are displayed if alarm 1
vated.
• The cuff automatically inflates. The cuff's air pressure is
slowly released. If a tendency for high blood pressure is
detected, the cuff re-inflates and the cuff's pressure is
increased again. As soon as a pulse is found, the pulse
symbol
• The cuff position control symbol
throughout the entire measurement. If the cuff is ap-
plied too tightly or too loosely, then
displayed. In such cases, the measurement is cancelled
after approx. 5 seconds and the device switches itself off.
Apply the cuff correctly and take a new measurement.
• The systolic pressure, diastolic pressure and pulse rate
measurements are displayed. A symbol in the display also
appears which shows you whether you were sufficiently
relaxed during the blood pressure measurement or not
(
rest). Observe the chapter "evaluating the results/resting
indicator measurement" in these instructions for use.
• You can cancel the measurement at any time by pressing
the START/STOP button
• _ appears if the measurement has not been performed
properly. Observe the chapter on error messages/trouble-
shooting in these instructions for use and repeat the
/ 2
is acti-
measurement.
1
• Now select the desired user memory by pressing the
2
memory button M. If you do not select a user memory,
55
will be displayed.
symbol = sufficiently at rest;
.
is displayed
and "
" are
symbol = not at
1
2
Publicidad
