Mitsubishi Electric Mr.SLIM PSA-MKA Serie Manual De Instalación página 18

6. Electrical work
Note:
Be sure to write down the settings for all functions if any of the initial settings has been changed after the completion of installation work.
en
Note:
Make the function settings shown in Function table as necessary.
16
Function setting
Ref. address
Unit No.
Grp./1/2/3/4/All
Monitor:
Cursor Address
Function setting
Ref. address Grp. 1/8
Mode 1
Mode 2
Mode 3
Mode 4
Save:
Page
Cursor
Common items
Function setting
Grp.
Ref. address 1/8
Mode 1
Mode 2
Mode 3
Mode 4
Request:
Value
Individual items
Function setting
Ref. address
Sending data
6.2.2. Function setting on the controller
Make the settings for the indoor unit functions via the controller as necessary.
Select "Function setting" from the Settings menu to bring up the Function setting
screen.
[Button operation]
1 Set the indoor unit refrigerant addresses and unit numbers with the F1 through
F4 buttons, and then press the SELECT button to confirm the current setting.
2 When data collection from the indoor units is completed, the current settings
appears highlighted. Non-highlighted items indicate that no function settings are
made. Screen appearance varies depending on the "Unit No." setting.
3 Toggle through the pages with the F3 or F4 button.
4 Select the mode number with the F1 or F2 button, and then press the SELECT
button.
5 Select the setting number with the F1 or F2 button.
Setting range for modes 1 through 28: 1 through 3
Setting range for modes 31 through 66: 1 through 15
6 When the settings are completed, press the SELECT button to send the setting
data from the remote controller to the indoor units.
7 When the transmission is successfully completed, the screen will return to the
Function setting screen.