Husqvarna LB 144i Manual De Usuario página 13

To assemble the handle
1. Fold the upper handle forward.
2. Tighten the handle knobs. (Fig. 18)
3. Pull the handle rearward until it is in the end position.
4. Fold down the height adjustment bail and put it into
the groove. (Fig. 19)
Introduction
WARNING:
product, you must read and understand the
safety chapter.
Husqvarna Connect
Husqvarna Connect is a free app for your mobile device.
The Husqvarna Connect app gives extended functions
for your Husqvarna product:
• Extended product information.
• Information about, and help with, product parts and
servicing.
To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Do the instruction steps in the Husqvarna Connect
app to connect and register the product.
To set the product in operation position
1. Assemble the handle. Refer to
handle on page 13 .
2. Adjust the handle height. Refer to
handle height on page 13 .
CAUTION:
too much tension in the cables. Too much
tension can cause damage to the cable if
the handle is folded into transport position.
WARNING:
unless the handle is fully folded up and set
in one of the applicable height positions.
To adjust the handle height on page
Refer to
13 .
To set the cutting height
The cutting height can be adjusted in 6 different steps.
1. Stop the engine.
1869 - 003 - 04.11.2022
Operation
Before you operate the
To assemble the
To adjust the
Make sure that there is not
Do not operate the product
5. Press down the height adjustment bail with your foot.
(Fig. 20)
To adjust the handle height
1. Press in the height adjustment bail with your foot.
2. Put the handlebar in the correct position and release
the handlebar. (Fig. 21)
2. Move the cutting height lever rearward to increase
the cutting height. (Fig. 22)
3. Move the cutting height lever forward to decrease
the cutting height.
CAUTION:
too low. The blades can hit the ground if the
surface of the lawn is not level.
Battery
WARNING:
you must read and understand the safety
chapter. You must also read and understand
the operator's manual for the battery and the
battery charger.
Keep the battery and the battery charger in correct
ambient temperatures.
Operation of the bat-
tery
Charging of the bat-
tery
Battery status
The display shows the remaining battery capacity and
if there are any problems with the battery. The battery
capacity is displayed for 5 seconds after the product is
switched off or the battery indicator button is pressed.
The warning symbol on the battery is lit when an error
Battery on page 17 .
has occurred. See
(Fig. 23)
LED lights
All LEDs are lit
LED 1, LED 2, LED 3 are
lit
LED 1, LED 2 are lit
LED 1 is lit
Do not set the cutting height
Before you use the battery,
Ambient temperature
5 °C - 40 °C
5 °C - 40 °C
Battery status
Fully charged (75-100%)
The battery is 50%-75%
charged
The battery is 25%-50%
charged
The battery is 0%-25%
charged.
13