DHG SystemRoMedic MiniLift200 Manual De Usuario página 9

How to reset the safety switch
PUSH
PUSH
1. Push down on the lift arm while holding the UP
button on the hand control for two seconds.
Changing the battery
1
Hand control
Raising/lowering the lift arm
Symbol indicate direction of travel.
Motion stops as soon as the button is released.
If the lift arm encounter an obstacle while lowering, the lift will immediately
stop the motion. In order to continue, the lift arm will need to be raised
slightly by using the hand control before further lowering.
Widening/narrowing the base
Markings on the buttons indicate function.
Motion stops as soon as the buttons are released.
I F U
HOLD 2 sec
1
HOLD 2 sec
2
PUSH
2. Push down on the lift arm while holding the DOWN
button on the hand control for two seconds.
2
1
HOLD 2 sec
2
9