Descargar Imprimir esta página

SodaStream GENESIS Guía De Usuario página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

SET UP
INSTALLING THE CO
1. Place the SodaStream
on a flat sturdy surface.
2. Remove seal and cap from the SodaStream CO
WARNING! Never insert or replace the CO
Plastic Carbonating Bottle is installed in the Sparkling
Water Maker. This can cause the Plastic Carbonating
Bottle to be ejected or burst.
3. Press the button located at the rear to release the
Sparkling Water Maker's head from the body. Pull the
Sparkling Water Maker's head upwards and remove it. Set it to
one side.
4. Insert the CO
Cylinder into the cylinder holder in the Sparkling
2
Water Maker's head and screw to the right while applying
gentle pressure until it is firmly held in place. WARNING!
Hand-tighten only. DO NOT use tools, this can damage the
Sparkling Water Maker or CO
in an uncontrolled flow of CO
Carbonating Bottle to burst.
5. Place the Sparkling Water Maker's head onto the Sparkling
Water Maker. Push down until you hear a click. Now you are
ready to create the bubbles.
SODASTREAM CO
Please note that the
SodaStream
Genesis
®/MD
is compatible with the
SodaStream CO
Screw
2
System Cylinder and is NOT
compatible with the
SodaStream
Quick
®/MD
Connect Cylinder.
CYLINDER
2
Genesis
Sparkling Water Maker
®/MD
TM/MC
Cylinder, which may result
2
gas, causing the
2
SCREW SYSTEM CYLINDER
2
COMPATIBLE SODASTREAM
CO
SCREW SYSTEM CYLINDER
2
TM/MC
Use Only SodaStream
®/MD
CO
Screw System Cylinder
2
Cylinder.
2
Cylinder while a
2
3
1
2
4
NON-COMPATIBLE
CO
QUICK CONNECT CYLINDER
2
1 5

Publicidad

loading