Dometic CU300 Serie Instrucciones De Montaje Y De Uso página 26

5. Screw the regulator into the new gas cylinder
by hand.
Replacing the hose
!
WARNING! Health hazard
• Replace the hose in a well-ventilated
area.
• Ensure that there are no open flames in
the area.
• Only replace the hose when the cook-
top and gas oven is switched off.
1. Close the gas valve on the gas cylinder.
2. Unscrew the regulator from the gas cylinder.
3. Replace the gas hose.
Troubleshooting
Fault
The device does not ignit.
26
4. Screw the regulator into the gas cylinder by
5. Check the gas hose for leakage using a foam-
Storage
!
1. Close the gas valve on the gas cylinder.
2. Clean the cooktop and gas oven (see chapter
Possible cause
The wrong gas is used.
The gas cylinder is empty.
The hose is defective.
A malfunction or poor connections
are present.
The thermocouple is defective.
The cooktop and gas oven is defec-
tive.
4445103985
hand.
ing agent, e. g. soap.
WARNING! Burn hazard
The cooktop and gas oven is very hot
while and after operating. Switch off the
cooktop and gas oven. Let the cooktop
and gas oven cool down before packing
up or transporting it.
"Cleaning and maintenance" on page 25).
Remedy
➤ Ensure to use suitable gas.
Observe the gas regulation
specification for the cooktop
and gas oven on the data plate.
and the specifications in chapter
"Technical data" on page 27.
➤ If necessary, replace the gas cyl-
inder (see chapter "Replacing
the gas cylinder" on page 25).
➤ Replace the gas cylinder (see
chapter "Replacing the gas cylin-
der" on page 25).
➤ Replace the hose (see chapter
"Replacing the hose" on
page 26).
➤ Reconnect the pipe or hose
(chapter "Connecting to the gas
cylinder" on page 23).
➤ If necessary, switch off the gas
supply and contact an autho-
rized service agent.
➤ Switch off the gas supply and
contact an authorized service
agent.
EN